Equipment set ups for your Turbulence.

[2kwik2c]

I've already posted what equipment I'll be putting on my Turbulence once I get my hands on it.  For those of you who missed it here it is again:
Cyclic Servos
Futaba BLS451

Throttle Servo
Futaba 9452

Gyro and Tail Servo
Futaba GY611 with BLS251 for tail servo

Powerplant
YS 91SR

Exhaust
Funtech HN90 Type F (might change it to a Hattori muffler for the YS.)

Governor
CYB ATG Governor (might chagne it to the Futba GV-1. I had much luck with this gov. plus I know how to set it up properly.)

Receiver
JR R921 and/or AR7100 ..we'll see

I'll be using MAH wide chord and/or V-Blade TST as main blades and V-blades for the tail blades.

How bout hearing from the ones who are getting this kit, what are you gonna put on it???

[paul_barsamian]

Here's my setup:

3 Futaba BLS 451 on cyclics/collective
1 Fut 9650 on throttle with GV01 driving it
Fut 601/BLS251 soon to be changed to 520/BLS251
FASST 608FS receiver
HPI regulator
Fromeco 2 cell 2600mAH LiIon rx pack
Mah 710mm Mains
Mah 95mm tails
OS Pumped HZ w/ Hatori SB20FH

[2kwik2c]

Hi Paul,

So you're using a HPI volt. regulator?  How do they fare?  The reason I'm asking is because I'm in the market for a new regulator for both my D3 and EVO 90.  I use to have a Align 2 in 1 volt reg and remote glow, but that didn't suit my D3 or EVO 90 well.  Then I change to the SG Reactor X on my D3 which is  OK at first until I begin to notice my Flight Power 2s is getting shorter flight times per charge. The most expensive volt reg. if you ask me.

  I'm looking at getting a perfectregulator, but heard that it wasn't too reliable.  So, I'm looking for something both reliable and reasonably priced.  What model is the HPI regulator? Have you got an experience with Fromenco Arizona volt reg.?  Thanks for any help.

[paul_barsamian]

I tested the MPI dual regulator and it holds voltage under load very well.  It dropped only 1/10th of a volt under 5 amp load and only 2/10ths under 8.5amp load.

For 24.95, it's probably the best bang for the buck that I've seen....

[dogg5306]

Here's my setup:
3 Futaba BLS 451 on cyclics/collective
1 Fut 9650 on throttle with GV01 driving it
Fut 601/BLS251 soon to be changed to 520/BLS251
FASST 608FS receiver
HPI regulator
Fromeco 2 cell 2600mAH LiIon rx pack
Mah 710mm Mains
Mah 95mm tails
OS Pumped HZ w/ Hatori SB20FH

Paul, be careful with your Fromeco LiIon pack as the 2 cells one is known not to be able to provide enough power to hungry servos... the 4 cells pack is OK

[bharkin]

Here is mine:
JR 8717 on cyclic
JR 890G on throttle
Futaba GY520/JR 8900G on the tail
SGP Reactor X running 6.8 to the cyclic and 5.3 everywhere else
YS 91SR3
Hatori SB19
Futaba GV-1
SwitchGlo